Programming the Cisco AP 1142 to operate as an Autonomous Access Point
This article aims to provide a framework of steps to be taken to configure a Cisco 1140 series Access Point to work as a stand alone unit that is connected…
Configuring a Cisco Router
In order to help us complete the basic configuration of our Cisco routers, this lesson introduces the use of configuration modes, and how they interact to help us configure the…
Cisco Aironet Access Point AIR-LAP1142N-A-K9 and AIR-AP1041N-A-K9 Firmware
If you wish to change your Cisco Access Point from lightweight (lwapp-k9w8) to a full-autonomous (k9w7) device for whatever reason, follow these steps to install the autonomous firmware on these…
Upgrade 1142 from LWAP to Autonomous
To upgrade a Cisco AIR-LAP1142N-A-K9 from the factory lightweight image to an autonomous image
Configuring a Cisco AP for Site Survey
Unless you want to have to connect your survey AP to the network to reach the WLC (an therefore having UTP cabling everywhere) or carry around and power a WLC…
Lightweight to Autonomous (vice versa) Conversion…
To convert Lightweight AP to Autonomous AP, need to have PC directly connected to AP’s ethernet port. If you are powering AP from the switch (i.e use PoE) then PC…
Configuring the Cisco 819-4G Cellular Router, Building Blocks
While there are a few mobile-specific pieces of configuration, anyone who has previously worked on ISDN, async modems or ADSL on Cisco routers will probably find a lot of familiar…
Getting Started Guide: Cisco 3700 Series Access Points
Getting Started Guide: Cisco 3700 Series Access Points